Originally posted by Manticore
NR, here you go
first hint
brake pad
exame if the backing metal plate is perfect flat. otherwise you need to twist the plate to ensure the plate is close to perfect flat. use rubber glue to stick the pad and plate together and use rubber hammer to hit the combo to ensure the pad sits properly on the plate.
second hint
slope on rear arm
The kit comes with two alloy shims to remove slope there but they are just about too thick. Use electric motor telfon shim to do the job. one piece on each side will do the job.
Kool,
Manti, I didn't see any extra alloy shims come with the kit for this?. Are you talking about the shims that are included so you can increase/decrease upper arm camber on rear hubs? If I recall, there is one thin and one thick one and standard setup requires to use both of them