Originally Posted by Hebiki
Lee
per Dan Garber's instructions in using the TA05 pulleys on the MSX. loosen the bulkheads, slide the front oneway or diff in... then slowly tighten down the bulkheads again using a star pattern. then secure the top portion using the same star pattern. its a snug fit, but it works.
- Chris
The rear TA05 diff you can built straight up witht the MSX alu diff parts.
For the front TA05 one way, we shave off a bit material as it is thicker in the center part as the MSX one way pully. We have taken off about 4/10 of a mm in a lathe on each side. Then it fits about the same as the MSX pully between the bulkheads.
Stein