Originally posted by dtm
There is a very easy way to seal up the edges of the carbon- per Xray manual. Use a cotton wool bud, couple of drops of CA onto that and then swipe the edges. You will need quite a few buds (because once the CA hardens its no good) and a VERY well ventilated area.
Well, I'm using the same method to seal the chassis, but somehow, it gets a little bit foggy around the edage of the chassis. Seems to be the vapor of the CA that's fogging up the chassis. But your chassis is soooo clean!, no fog at all. Did you use the new Tamiya no-fog type CA???