R/C Tech Forums - View Single Post - good asphalt setup for a hot bodies cyclone
Old 05-17-2006, 08:07 PM
  #4  
tc3 racer sc
Tech Fanatic
 
tc3 racer sc's Avatar
 
Join Date: Jul 2003
Location: lancaster sc near charlotte nc
Posts: 921
Default

Originally Posted by KilRuf
Just download some setups off of www.hotbodiesonline.net or www.rczone.net I started with a spool and the Reedy Race USA setup is a good starting point for that. I was using premounted Sorex 36r. I ran stock with a Mazda6. I switched rear toe block from 3degrees to 2degrees. And went from there. Also, as everyone would say.......check the cyclone forum too.. hehe..
LIKE kilruf said there plenty on hotbodies site, and hpi racing .com site under cyclone i used the reedy race set up/ cpl good ones on hpi site
tc3 racer sc is offline