What standards are you going to use with this motor??? Are you going to dyno it past 42.000 rpm's??? Are you going to use 20% nitro and a Nova Pipe??? These things are important to know... I believe your other .12 dyno tests were done using a certain standard guide lines... If you do use 30-40 percent nitro and there pipe, please info the public that you did and if you can, run two tests... One with there pipe and whatever nitro % and the other using what the average Joe would use/run with this motor or the standard that you always test with... Looking forward to the results.
RC_Alan
RC_Alan,
I will test this engine as I have tested all the other engines in my database. Except in this engines case I will let it rev past 42,000 rpm (due to the manufacturers claims of extremely high rpm capabilities).
If you look carefully in all my dyno runs, I include the fuel type and % used also I include the glow plug and pipe used during testing.
I will usually test each engine with a variety of pipes and only display the run that I feel made the best power.
In the Orion CRF's case, Orion does not have their exhaust pipes ready to send yet, therefore I am stuck using what is currently available on the market. When Orion sends me thier CRF specific pipes, I will retest the engine and repost the results to my website.
BK