Originally Posted by mxwrench
I finally have my CRF sample in my hands. I will get busy and test this engine and report as soon as I have my results.
I have inspected the engine and I can say I am impressed so far with the workmanship and all that I have seen.
Stay tuned....
What standards are you going to use with this motor??? Are you going to dyno it past 42.000 rpm's??? Are you going to use 20% nitro and a Nova Pipe??? These things are important to know... I believe your other .12 dyno tests were done using a certain standard guide lines... If you do use 30-40 percent nitro and there pipe, please info the public that you did and if you can, run two tests... One with there pipe and whatever nitro % and the other using what the average Joe would use/run with this motor or the standard that you always test with... Looking forward to the results.
RC_Alan