View Single Post
Old 05-08-2006, 01:08 AM
  #6407  
ae_ntc3
Tech Addict
 
Join Date: Jan 2006
Location: it's only illegal if you get caught!
Posts: 562
Default

Originally Posted by rmdhawaii
Hmmmm...

This is the VZW010;
http://www.rcmart.com/catalog/popup_...D=6548&picID=1 Why are you using the 2mm spacer? Is it because the wheel shaft hole for the hexes are too far out? That might be your problem. If you unscrew pivot balls 2mm do you see any threads? What happens when you put the stock hexes back on the car? Do you still need the 2mm spacer?
if i take the 2mm spacer out of the rear then i have to shim the axle from the inside of the hub. il have to shim it 2mm to pull the pin hole coser towards the car otherwise if i don't shim it up and take the spacer out then the axle will be 'floating' in the hub.
ae_ntc3 is offline  
Reply With Quote