POPSRACER
I know I only quite smoking crack about 10 minutes ago, but I swear I ordered the trinity tool. I swear I received it. I swear I opened it. I swear it said TRINITY on it, and I am telling you. It has the bar that goes through the brush hoods and a shaft that goes through the bearings or bushings. there are also holes on each side of the bar that goes through the brush hoods so if you are aligning a mod or a stock, you can still use the 1/8" diameter shaft.
Quite looking at that ad on the second page of RCCA from a couple of months ago, and acctually order one to find out.