R/C Tech Forums - View Single Post - Mugen MTX-4
Thread: Mugen MTX-4
View Single Post
Old 04-21-2006, 12:25 PM
  #4438  
GrandeGixxer
Tech Elite
iTrader: (21)
 
GrandeGixxer's Avatar
 
Join Date: Jun 2004
Location: Waldorf, MD
Posts: 3,322
Trader Rating: 21 (100%+)
Smile

Jeff, I will give you my set-up I ran for the toys for tots race. I didn't do very well, but my car was very fast. If I had finished a qualifier I would have been either high in the C or maybe in the B.

JP modified T03 with Mugen p1002 pipe. grey clutch shoe with light shoes and hard JP spring. set .08 preload and .01 endplay.
Stock gearing with 24t front pulley.

front: 600w stock pistons light blue springs, track at 198mm
42 shore tires cut to 61mm ride height 5, droop 1, caster centered, 1* out toe, flat roll bar, camber at 2*.

rear: 400w, stock pistons, light blue springs, 40 shore tires cut to 63mm, 1.5* toe in, roll bar off, camber links no spacers middle hole, camber at 2.5 ride height 5.5mm, droop at 5, 30,000 diff fluid. Track at 200mm

Good luck at the race, I wish I could make it out there for it. This setup should give you a good place to start out with.
GrandeGixxer is offline