kind of a dumb question but I was looking at some of the set-up sheets and I see that some racers have 0deg for their toe-in and I was wondering if they somehow modified the rear block so that the toe-in in the rear equaled 0deg or are they using the stock rear block that has 0deg of toe-in but the stock kit has 2deg automatically. I was wondering this because Losi on makes 0,1/2, and 1 degree rear blocks. So the rear will always have 2,2 1/2, and 3 degree of toe-in at all times. I guess maybe on their setup sheets they tell you the actual block they used instead of the total amount of toe-in. Also the Pivot-blocks are the same thing as Kick-up in the front and anti-squat in the rear correct?
One last question. IF I use the 4F piviot block up front doesn't that give me 4deg of Caster? so then I would use the stock 0deg Caster block. Or I use the 0F piviot block and then use the 4deg caster block for the same setting...or do these settings each do different things?
Thanks
Mike Webb