Originally Posted by ralph_c
I found short neck black ballstuds at the back camber link with no washers helped the car get into the corners better (higher roll center). Might help someone else I guess.
i use the short black studs in the rear with 1~2 washers depending on grip.
small question TC4 folks...
If I use a one-way in front, should i use steel outdrives or plastic outdrive in the
FRONT with alum or carbon cvd's ?
If I use a one-way in front, should i use steel outdrives or plastic outdrives in the
REAR with alum or carbon CVD's?
I was thinking,
front one way with steel outdrives and alum cvd's and rear with plastic outdrives and carbon outdrives to carry the speed? Hope I am thinking right here.
Thanks!!