R/C Tech Forums - View Single Post - Changing Rotostart for Pullstart
Thread: Changing Rotostart for Pullstart
View Single Post
Old 04-10-2006 | 12:01 AM
  #13  
wanabedriver
Tech Initiate
 
Joined: Mar 2006
Posts: 43
Default
I ended up buying the HPI pullstart for $26 from my LHS. Ouch, wished it could be less... Then again, the rotostart, handheld part they were willing to sell me was $40. If I go back before I start it up, I will hope they have the $5 starter shaft I can use with my drill.
Last edited by wanabedriver; 04-10-2006 at 12:47 AM.
wanabedriver is offline  
Reply