Originally Posted by Guo Chean
Hey i was trying to put the TA05 front oneway pulley into my TRF 415 front spool but i cannot fit the 3 screw front the pulley to my spool. may i know did you guy do some modification on the pulley so it can fit well on my 415 spool? thanks
I just put all 3 screws in at the same time, and did each up a little at a time, it was tight, but now i know the pulley is 100% centered. When putting the 1 way back in make sure you loosen all the bulkhead and shock tower screws as the finished 1way assembly is fractionally wider between the bearings. I rememdied this by removing a bit of the flange off the plastic bearing carrier so that it sits deeper into the bulkhead.