Hey Good people!
I have a question for ya's, a couple of weeks back I sat down and read this thread and others from start to finish taking notes here and there, I noted and from memory it was Dino that wrote his LSN was approx 4 turns out and his HSN was approx 1.5 - 2 turns out. Is this correct?
If so, can you tell me if the top of the LSN is pretty much flush with the brass bit (#21050B)?
I ask as up until now the LSN has been way further out than it is now and my HSN has also been way further out that it is now. I am not sure whether these settings are safe to try!