Originally posted by Tres
OK, here is what the switch does........
You have 2 sides of the switch.
Side one:
Has 2 leads coming from it
One has red & black wires(a)
ones has Red, black & yellow(b)
Side two:
Has one lead coming from it
Red, black & yellow(c)
All the switch does is switch the red wire.
It connects the red wire from(a) to the red wire from either (b) or (c) depending upon switch location.
The yellow from (b) connects directly to the the yellow from (c)
The black from (b) connects directly to the black from (c)
Neither one is controlled by the switch.
With the switch in the ON position:
(a) connects to (c)
This is the position for RUN/DSC
With the switch in the OFF postion:
(a) connects to (b)
This is the postion for charge
(a) connects to the battery
(b) is the charge/DSC connector
(c) connects to the Rx
Click on image below...
Is this what you where looking for?
If not, let us know....
Does this mean that you have to disconnect your failsafe in order to use the DSC?
TIA. Jim.