Originally posted by ROBBIE C
Earlier I posted the proper way of fixing the brake problem, sounds like no one paid attention, so here it is again.
grind down the brake guide on the rear cross member, this should solve your problem.
I listened!
I came to the same conclusion. I did a bit of everything!
Sanded the brake pads.
Sanded the brake guide on the rear brace.
Bent the pins VERY slightly (I'm not sure if this is necessary)
I just kept tweeking untill I was happy. It involved stripping the rear end about ten times checking every componant but as I said in an earlier post sure this is half the fun of building!
All the best