R/C Tech Forums - View Single Post - Kyosho v-one rrr
View Single Post
Old 02-12-2006, 11:38 PM
  #4970  
jeffreylin
Tech Elite
 
jeffreylin's Avatar
 
Join Date: Nov 2003
Location: Traction Roll!
Posts: 2,564
Default

Originally Posted by rmdhawaii
I just built a V-ONE RRR WC Edition car with a OS TZ .12 3-port engine w/slide carb. After going through two tanks of Nitro on the starter box, I tried to run the car, but the clutch was really late in engaging. A buddy of mine took a look at it and tried to adjust it (we even took the whole clutch assembly to verify that I built it right), but we couldn't the setting right. The engine is running rich and my friend did fuss with the idle speed adjustment.

Anybody have similar problems?
Got any suggestions?

Thanks!

BTW: The TZ is really tight at TDC, even after going through two tanks of fuel.
It takes much more than 2 tanks to break in a motor. 10 tanks is more like it.

Your engine setting is too rich. This is fine as it is set for break in. But you should gradually lean it after say 5-6 tanks.

If you need to know how to break in your engine here is a good article you can read:

http://www.cefx.net/tips/nitro/break-in/index.php
jeffreylin is offline