R/C Tech Forums - View Single Post - gearing help
Thread: gearing help
View Single Post
Old 11-20-2002, 11:13 PM
  #2  
-CriMinaL- |RC
Tech Adept
 
-CriMinaL- |RC's Avatar
 
Join Date: Nov 2002
Location: Sydney, AUS
Posts: 246
Default RE: gearing

Hey Racerb

if your are talking teeth number rather then ratios i would suggest this:

I ran a similar motor and used a 90t spur / 31t pinion.

It gave me relatively good acceleration and a fair bit of top end speed, without getting too hot.

It also depends on what type of track you are running on, length of straights surface etc.

hope this helps
-CriMinaL- |RC is offline