R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 02-06-2006 | 02:09 PM
  #17268  
dakrat's Avatar
dakrat
Tech Master
 
Joined: Nov 2004
Posts: 1,581
From: 96th ABW
Default
Originally Posted by Fast Faisal
Hi All,

Is there any good or bad position to mount ball studs for steering on the servo saver? For example, there are 3 hole positions on my saver, top, middle and bottom, does it matter where? In addition, does mounting the ball studs facing front or back of the car have any significant effectiveness?

Thanks
Fast Faisal
if you have a dynamic front end, look at the steering link angle. make sure it goes between the upper and lower arm and not binding when fully turned. mine is in the middle hole
dakrat is offline  
Reply