Hello people

I have bought the serpent 710 ith the Centax III clutch. I have some guestions about assembeling the thing.
I have shimmed the clutchbell at 0.6\0.7 mm and then started to look at the endplay, with everything installed and clutchbell play set like above i want to shim the endplay. It say's in the manual "reduce the endplay to minimal with the use off shims right after the springnut", so i need to shim it so that the clutchbell has minimal movement on the crankshaft axel? I ask this because the clutchbell can move over 1mm on the shaft? Do i need to shim it so that the clutchbell has minimal movement? If yes, doesnt that affect the clutchbell setting off 0.6\0.7mm ??

Maybe a dumb question but i find it difficult to read exactly what the manual means with endplay (Me being dutch with a englisch manual can cause this)
Thanks for any advice on this!!

Ron