Hi guys...
(first post, yiihaa)

I bought a brand new Mega zx12 engine. When I started to fit the centax, I realised that the crankshaft is only 6mm, making the 7mm brass cone supplied with the 710 kit useless...

The zx12 is supplied with a steel cone approx 0,5mm "longer" than the brass one in the s710 kit. Is it possible to use the steel one without the 0,5 shim or is there a 6mm brass cone available?? (all info I can find is "use the cone supplied in 710 kit", but what if it doesn't fit???)

Anybody with experience fitting the zx12 in a 710??

Feels kinda strange that the Mega doesn't fit the 710, they are produced by the same company after all...

Hope you guys can give me some advice.