Thread: NEW XRAY T2
View Single Post
Old 01-30-2006, 10:51 AM   #2430
Team EAM
EAMotorsports's Avatar
Join Date: Dec 2001
Location: Murfreesboro, TN
Posts: 9,201
Trader Rating: 79 (100%+)
Send a message via AIM to EAMotorsports

Originally Posted by HRCRACER123
First of all I was talking about my FK'05. If you look at the bottom of the chassis with the screw put in the bulkhead. They should have either not countersunk the holes so much or give us bigger screw heads so that it would grip the carbon fiber better.The screws just rip right through it. I would never run any screws lower than the chassis or reccommend anyone else doing so. Its all good.
My bad...I missed the part of Fk05.... I know some guys did have a problem with that at one point and they took the center screw out and never had a problem after that....

I agree the screws that came with the FK05 did suck...they stripped out very easy...The T2's that I have seen seem to have better screws in them though...Havent heard of anyone having a problem with them yet...Thats a good thing I guess.

Contact Us
Team EAM, Our Facebook
Team EAM | APEX Raceway and Hobbies.
EAMotorsports is offline   Reply With Quote