Thread: NEW XRAY T2
View Single Post
Old 01-30-2006, 10:47 AM
Tech Fanatic
iTrader: (33)
HRCRACER123's Avatar
Join Date: Apr 2005
Location: Long Island, New York
Posts: 819
Trader Rating: 33 (100%+)

Originally Posted by EAMotorsports
Yea I could see it now at the drivers meetings "All T2 drivers must run 6mm ride height to keep their front chassis screws from draging the carpet"
First of all I was talking about my FK'05. If you look at the bottom of the chassis with the screw put in the bulkhead. They should have either not countersunk the holes so much or give us bigger screw heads so that it would grip the carbon fiber better.The screws just rip right through it. I would never run any screws lower than the chassis or reccommend anyone else doing so. Its all good.
HRCRACER123 is offline  
Reply With Quote