question
has anyone used the
Aluminum Suspension Holder (hinge pin holder)
Made By SQUARE??
They make it for the front 1.5degrees and rear 2.5degrees.
Plan to get one to prevent looseness, breakage and changes in the handling if you clip a corner?
Wha t do you think?
I think AE should make suspension holders like the one LOSI did for it XXX-s (i think its the matt francis line, and speed tech RC also have their own)
TPhalen: I think AE should look into building this stuff, or at least make a study.
SPEEDTECHRC: do you think there is a possibility of producing this? like the ones you did for the XXX-s??
Last edited by lem2; 11-15-2002 at 07:42 AM.