R/C Tech Forums - View Single Post - Serpent 710
Thread: Serpent 710
View Single Post
Old 01-14-2006 | 08:13 AM
  #22852  
adl
Tech Initiate
 
Joined: Oct 2005
Posts: 42
From: los angeles
Default

Originally Posted by hooked_on
Hi Guys,

It's been awhile since i have looked at the S710. I did get one when they first came out, but i had problems with the clutch and gave up in frustration. I think looking back it was more user inflicted pain rather then anything else...

I am looking at a few options for the 2006 season and wondered if there is anything major that is required after the kit purchase? I do remember breaking a front dogbone in the early stages. But i see Serpent have released CVD's, however i just read that it isn't a good idea to use these with the front spool:S

Also,

Is there anything else required to finish off the rear gear diff (#802600) or is it just add oil and it is RTR?

I have seen things being posted about a new chassis could be released soon, i know Serpent have not commented publicily about it, but RC-Mushroom have dropped the price on the S710 too

I look forward to reading your replies.

H_O
i have the cvds in front with the ball diff and it works just fine actually it is smooother than with a dog bone also it seems like you can set the end point just a little bit more if you need to without any binding
adl is offline