R/C Tech Forums - View Single Post - lathe 'V' groove or Bearings
Thread: lathe 'V' groove or Bearings
View Single Post
Old 01-10-2006, 02:05 PM
  #4  
Matt Howard
Tech Champion
iTrader: (6)
 
Matt Howard's Avatar
 
Join Date: Aug 2001
Location: Abilene TX
Posts: 5,954
Trader Rating: 6 (100%+)
Default
V groove, and get a diamond bit while you're at it. I'm running the same diamond bit and V groove blocks in my ancient Twister lathe since the day I bought it.
Matt Howard is offline  
Reply