R/C Tech Forums - View Single Post - Setting up an Integy xipp super lathe 3
Thread
:
Setting up an Integy xipp super lathe 3
View Single Post
12-30-2005, 01:44 AM
#
21
Steveh
Tech Rookie
Join Date: Aug 2005
Location: Chicago
Posts: 11
Trader Rating
: 0
Yeah I'm cutting from left to right. I haven't used it much as it's just a spare lathe, but I ran it on a 6 cell pack. It ran a little slow at that speed, so i'd run it from a 12v power supply to get the best cut.
Steve
Reply
Steveh
View Public Profile
Visit Steveh's homepage!
Find More Posts by Steveh
View iTrader Profile