Thread: Hobao GPX4 Pro
View Single Post
Old 12-27-2005, 05:53 AM   #132
mykel chua
Tech Addict
 
Join Date: Jun 2005
Location: Cebu
Posts: 594
Trader Rating: 1 (100%+)
Send a message via Yahoo to mykel chua
Default

Quote:
Originally Posted by three50zx
Yes.
1. Just loosen part number 22060 called the "spring adjust nut" because if it's too tight the clutch bell will not engage and the car won't move.
2. Loosen the spring adjust nut but make sure you don't unscrew it off of 22066 "engine nut".
3. After the necessary adjustment is made you should start the car up and leave it on your starter box
4. Apply throttle and your wheels should move. There is no need to go to the track to see if this is the problem unless your town has a noise ordinance.

Hope this helps if not let us know.

Good luck

thanks for the help sir. i got it running already. was at the local track the whole afternoon and asked for some help there too. apparently i also had to shave off a few mm's off the diff case's bearing area. again, thanks for the help and more power to you!
mykel chua is offline   Reply With Quote