Scott,

Thanks for the correction. My use of the term axle shaft was incorrect adn I thank you for pointing that out.

Here is the reason I am asking. I see that there are complete assemblies made of Titanium that incorporate the CVD, dog bone and axle shaft as one piece.

I was considering these on the MTX4 and was attempting to gather enough information on the forum here to enlighten me so I could make the swap.

The CVD set I have found are for the MTX 3 and the ad states "front or rear".
It these will fit the MTX3, then will they also fit the MTX4?

I believe that in your answer you more or less answered my question, but I thought that perhaps a more direct and specific question would be better.

Thanks,

Stew