Originally Posted by Stew
This may have already been covered, but I didn't fel like reading through 100 post replies.
Are the axle shaft lengths on the MTX3 the same overall length as the new MTX4? AND are the length of the front's the same as the rear?
Thanks,
Stew
The axle shaft is the piece that fits through the upright and is threaded for the wheel nut. They are the same on both cars. The dogbones are also the same. If you use CVD's, the MTX4 uses a new length for the rear that just became available. On the front of the 4, many people use the MTX3 rear cvds (mugen suggests these). Some people including myself use the MTX3 rear cvd's on the front of the mtx4.