Originally Posted by f2000racer
Where do I find these info about B-B B+B???
Is there another setup book about this??
Thanks.
The original 415MS "Worlds Kit" that came with the 1XA, 1XB.... blocks has all the blocks = degree toe for front and rear.
For regular suspension arms and regular blocks (1A, 1B...) , page 20 from a 415 manual.
For lightweight arms and regular blocks (1A, 1B...), page 20 from a 415MS manual.
For lightweight arms and "X" blocks (1XA, 1XB...) page page 20 from a 415MSX manual.
Some of the manuals list the set-ups based on 1 degree rear hub, some on 0 degree hub so you need to check closely for that.
For your TA05 sway bars, the front and rear use a link connected to a ball nut you screw into the lower A arm. The link is basically two turnbuckle ends trimmed with a 10 or 12mm grub screw between them to make your link from the sway bar to the lower A arm.