R/C Tech Forums - View Single Post - Slapmaster Tools MS2.3
View Single Post
Old 12-19-2005, 10:07 PM
  #82  
Slapmaster6000
Tech Elite
iTrader: (16)
 
Slapmaster6000's Avatar
 
Join Date: Sep 2004
Location: Edmonds, Wash.
Posts: 3,188
Trader Rating: 16 (100%+)
Default

I haven't been to Cali to race since Sept. Hope I remember where I left it.

I am looking forward to the Nat's and show casing Weylin in the MS2.3. He is already kicking my butt with the set up that I put on his car by a 1/4 of a second! I'm so impressed with him. No wonder Schumacher has him under their wings.

For anyone interested, I have a fresh batch of thrust bearings ready to go. If you are getting tired of replacing those 1/4x3/8" bearings in your diff, upgrade to my thrust kit and never worry about your diff again in the near future. I am running two diffs now that are pushing two years worth of racing on the same balls and plates. The only thing that I change will be the spur gear if I don't get out of the corner soon enough!

Brian; Slapmaster Tools, www.slapmastertools.com, [email protected]
Slapmaster6000 is offline