R/C Tech Forums - View Single Post - Crank Question
Thread: Crank Question
View Single Post
Old 12-15-2005 | 10:23 PM
  #3  
EdwardN's Avatar
EdwardN
Tech Elite
iTrader: (1)
 
Joined: May 2003
Posts: 2,168
From: SoCal
Default
it is absolutly normal-it is EFRA cranck. Main bore is 8 mm and to meet EFRA ruls they ade on exit 6.95 mm. If you are able to bore with dremel it will help on performance slightly, but make sure you don't touch cranck pin with dremel's bit-then it will be ruined.
Edward
EdwardN is offline  
Reply