Firstly, sorry to hear about the fire at your workplace Eduard. Hope there isn't too much damage and it'll be up and running again soon. Fire is always a big risk with textiles.
Secondly, just a little feedback on my PR 12.
Ran 10 tanks through it already. Starting to feel the power com ein, especially at the high end. Low end is still sluggish. Engine temp after running 1/2 a tank is around 115C.
I would like to know how rish should I run the low end. Right now, the low end is at factory setting and is quite rich. If I let the engine idle for around 15seconds, it'll die. Should I lean the low end? or just work on the high end needle?
Cheers.