View Single Post
Old 11-30-2005, 07:31 AM   #621
Riketsu
Tech Elite
 
Riketsu's Avatar
 
Join Date: Aug 2004
Location: Puerto Rico
Posts: 2,520
Trader Rating: 32 (100%+)
Send a message via AIM to Riketsu
Default

Quote:
Originally Posted by jag
Still working well?
What settings are you using on that NR carb? I just installed an RB carb on my new ZX12 for break-in and found that I needed to lean both screws quite a bit (especially the low speed) to get the engine up to temp. I know I will have to richen them up when I put the engine in the car but I am curious what you are using.

Thanks,
jag
Mega Picco carb works just fine. The engine just likes it rich on both needles. It should start very rich the first few laps, then lean itself. My engine is about 6 turns out on the low needle and about 5.5 on the high. This changes with every engine/fuel used. But maybe using a NR carb will work better for you.
Riketsu is offline   Reply With Quote