TC4 chassis
I was finally getting around to putting together my TC4 chassis and had a questiong about the stand-off's included with the kit. There are eight small 1/4" (approx.) stand-off's that I believe were said to be for the diff's, is that correct? When I installed them, the bearing support for the rear input shaft was to far off the lower plate and the diffs appeared to be hovering out in space. I removed them and all is well. What are the stand-off's for if not for the diffs?
Also, does anyone have a base setup for stock carpet and asphault that they can post or email? I was going to use the most rescent setup from the team chassis for asphault but I have not run on carpet with it yet so I have no starting point for reference.
Thanks in advance.