Hi Guys,
Been doing my MTX4 build now and i am wondering why the front belt is a bit loose not like the rear, as the manual says, i should use the 5mm for the front and the 6mm for the rear, what pulley should i use for the front belt assembly and the rear and the side belt as well, also, my kit comes with only 1 side belt and its very loose after i installed it, its so loose that when you pinch the belt in the middle, the inside would almost touch each other (as shown in the pic), im afraid that if i install the belt tensioner, it would be so low that i would not have any more adjustments after the first run-in. Does any of your kit also comes with 1 side belt or you did purchase a shorter one.
Thanks.