R/C Tech Forums - View Single Post - Kyosho VoneR Thread
View Single Post
Old 08-23-2001, 08:48 AM
  #1  
neons
Tech Apprentice
 
Join Date: Aug 2001
Posts: 62
Default Kyosho VoneR Thread

Hi Guys...

Lets start this one up again...

I have 1 question:

I have a VoneR, and it was running a little rough, so I tore it down to clean it all (as in down to the last screw/bearing), and rebuilt it...now there seems to be some binding in the rear end...

When I push the car forward, it'll roll maybe 1 ft. at the most before it comes to a halt, and its a pretty rough 1 ft...I blasted all the bearings, and re-lubed them with bearing oil, and they run pretty free, and a couple feel a little gritty, but not blown...

Its not the brake/brake disk becuase I can unscrew the pads all the way out and it'll still have the exact same feeling...

I've tried taking the engine out, and it still does the same thing.

How "FREE" is the drivetrain supposed to be? Should I be able to roll it and have it roll for 5-10 ft without it feeling like there's a lot of resistance?

Any help/insight would help.

Thanks

Jeremy
neons is offline