Any one else having problems with the VCS bobbin not snapping down into place inside the shock? I've had two shocks begin leaking recently because the VCS bobbin doesn't stay in place snapped down into its groove. I have even tried buying the flat square shock part used in the older AE shocks that snaps down into the groove above the o-rings. I can not get them to snap down into the shock body. I am using the yokomo caps so I dont need the bobbin. I can't get the original bobbin or any of the lock washers I bought to fix this problem to seat and compress the o-rings like they should. Am I missing something? It almost makes me think the problem is the shock body groove not being small enough to hold the lock washer. I cant imagine the aluminum would wear at all.