R/C Tech Forums - View Single Post - Speedmerchant Rev.4
Thread: Speedmerchant Rev.4
View Single Post
Old 10-19-2005, 08:42 PM
  #228  
Mabuchi540
Tech Master
 
Join Date: May 2004
Location: New Zealand
Posts: 1,204
Unhappy Unfortunatley you are correct.....
Originally Posted by crimson eagle
Try putting the motor in the other way around, if it leans in the other direction then it's the motor and that I have nevr heard of before. Bent pod pates happen all the time. it is possible the pod plate on the other side is misaligned which would cause the problem but that doesn't seem likely.... but then again niether does a bent motor can.

Chris
I mounted the motor with the leads at the bottom this time and rather than lean towards the axel it does indeed lean away from it.

Damn!

Edit: Even my 540 Johnson stock motor sits in the pod better (just tried it to triple check).
Last edited by Mabuchi540; 10-19-2005 at 09:35 PM.
Mabuchi540 is offline  
Reply