R/C Tech Forums - View Single Post - Hpi Pro 4
Thread: Hpi Pro 4
View Single Post
Old 10-18-2005, 09:33 PM
  #13162  
fjm9898
Tech Elite
iTrader: (11)
 
fjm9898's Avatar
 
Join Date: Mar 2005
Location: Redmond, WA
Posts: 3,003
Trader Rating: 11 (100%+)
Default

hey i just found somthing out and i wanted to see if anyone else had noticed this because i havent seen a post about it or a pic.

if you have a personal with its tabs then your in luck. i was putting my PT back on after the servo tape wore out and i noticed that the tabs are equal spaced to the two holes on the topdeck that go into the steering rack posts. so if your tired of the tape and dont really care about the smal change in your CG height then jsut screw it down and never have to worry about tape again. noi am not to sure how well it works if you ahve the o rings and cone washes mod on there. but since this is my carpet car i really dont need the flex so it can go right down. but hey i think it would stuff work with the oring mod, just under the oring
fjm9898 is offline