R/C Tech Forums - View Single Post - P5 settings
Thread: P5 settings
View Single Post
Old 10-15-2005, 09:37 PM
  #9  
o.s. power
Tech Master
iTrader: (14)
 
Join Date: May 2005
Location: michigan
Posts: 1,678
Trader Rating: 14 (100%+)
Default

Originally Posted by augerpro
OS power think you were on to something. My hsn is 4 turns out! Maybe the rich hsn was overpowering the lsn making me cut it back so far. Only got an hour before the race tomarrow to figure it out. I think I'll cut the hsn 1/2 turn and open the lsn 1/2 turn then tune from there.

And yes it smoked pretty good all the time, but really puffed if it stopped for a few seconds.

yes that will cause your problem.

The way these carbs work, something that regan leblanc told me years ago, is that the high speed needle actually controls how much overall fuel gets to the motor. It does control the high speed settings, as the name implies, but an overly rich high speed will bog the motor down at all speeds and make it load up at idle.

to control your engine temperature, play with the low speed needle. too hot, richen it up by an hour.

you might have to re-adjust your idle too, so keep that in mind.
o.s. power is offline