R/C Tech Forums - View Single Post - Tamiya TB-Evolution IV
Thread: Tamiya TB-Evolution IV
View Single Post
Old 10-15-2005 | 08:13 PM
  #3157  
CAMS RC's Avatar
CAMS RC
Tech Apprentice
 
Joined: Jul 2005
Posts: 69
From: Sydney Australia
Default
Originally Posted by F. Alonso
Hi,

What type of rim are you using? If its THAT close (as you say above) then try just one of the shims, not both. I've used Sorex rims, Schumacher rims, ProLine rims, Tamiya rims and Speedmind rims without a problem. Should be okay.
Hello Simon

I am currentlly using speed mind, Sorex & yokomo rims (all dish).
I was using the single blue one but found it too tight to turning ball joint on wheel hub, I will have to check again maybe the nut contact area on rim might be a problem area as well.

thanks

jeffrey, I will look out for the Kawahara stuff.

Thanks
CAMS RC is offline  
Reply