Originally Posted by Scott B

Thanks rc-zombie,

As for the tamiya univ., the drive shaft is a little shorter, and the axle is the same but the mounting hole for the drive shaft is a little more to the outside so all togehter its almost the same length. Plus the tamiya axles have two sets of pin holes for mounting the drive shaft, so when one wears out you can switch it to the other.

I haven't run it at SWR yet, only on carpet at Stockton last Sat. with my new Novak Brushless. So I didn't do to well with breaking every run and trying to fing the rollout for the Brushless, but Billy and I are going to go next Wendsday night.