Originally Posted by JRRobiso
Thanks for the reply Max (MaxPower) & also on the heads up re the MSX conv kit @
Ultimate Hobbies. Checked out their website & also free shipping for internet & mail orders.
The only thing they did'nt have on their website was the lt wt rev susp kits.
I previously installed 415 susp blocks on my 414M (extremely TRF'd hopped-up). I'm still in the process of setting it up to run properly for my asphalt track. I currently have in the front B/X & the rear B/B. I know the 414 has it's own thread but since you mentioned your 414M2, was wondering if you can post or pm me your set-up on your 414M2 when you get a chance.
Thanks again.
Here's Surikarn ITSC setup. It works well but you won't be able to use as much spacers under the blocks as him without dremelling the wishbones. However, you can use the same setup with Evo3/4 blocks and the following spacers :
front end :
front 0
rear 1
turnbuckle : 2.5
rear end :
front 2mm
rear 0.5mm
turnbuckle 5mm
I've tried that setup, it works great on asphalt and on carpet aswell.
regarding the blocks it goes like this :
414M blocks are the lowest, 415 are 1mm higher and Evo3/4 are 2mm higher (than 414M blocks).