mafia - It's for the Jammin' car...no drill press for you!
D Mac - Turned all the way up! I like my cars twitchy...you don't have to use all of the wheel's throw.
losirunner - Well..that doesn't sound like too bad of a trade, but you have to remember that Kyosho is on their third kit since the K2.
lostagresiva - Trinity TK5071 is a one degree hub..I'm not sure if they make them anymore. Use them with the short arm option in the rear to keep your car the same width, and put the right hub on the left side (and vice versa) to take away toe-in. You could do the same with two degree hubs to only have 1 degree per side.
duanef - The AD1 rear pivot block will fit the AD2, but you'll have less toe-in. The AD1 block is three degrees per side, the AD2 block is four degrees per side.