R/C Tech Forums - View Single Post - modified engines
Thread: modified engines
View Single Post
Old 10-01-2005 | 07:35 AM
  #28  
EdwardN's Avatar
EdwardN
Tech Elite
iTrader: (1)
 
Joined: May 2003
Posts: 2,168
From: SoCal
Default
Hey Stefan.
No, these numbers are not for PS12, there was 25 to open and 75 to close. On pic I just showed how I work with protractor and pointer.
About get BDC-I do the same-jst the difference is, when I work on cranck-I use loos p/l set with new conrod (I can afford it ). So I am removing play from every (conrod on cranck pin, conrod/wrist pin/[iston) the rest the same as you.
Hey Dieter, I do use formulas, but when I work on designs of engines, when it comes to real metal I use protractor.
Edward
Last edited by Top Gun 777; 10-01-2005 at 08:00 AM.
EdwardN is offline  
Reply