R/C Tech Forums - View Single Post - Lynx 3D Control Issues
View Single Post
Old 09-19-2005 | 08:20 AM
  #3  
simba350's Avatar
simba350
Tech Addict
iTrader: (15)
 
Joined: Jul 2004
Posts: 704
From: Where the beer's at...
Default Lynx 3D control issues.

First found problem when running car outside, so range varied from a couple of feet to probably 50 or 60 feet, and have same problem on bench inside house. I installed the Lynx module into the Futaba aircraft TX I mentioned and performed the same tests with the car performing flawlessly. I had thought it may just be a dry join on a solder joint inside TX, and on inspection, found one where antenna mount is soldered to board. Re-soldered joint and tested again with same result. Was unable to see any other dry joins.
simba350 is offline