Originally Posted by Qlone
This weekend my 710 developed a problem. My front belt started to loose some teeth, so I replaced it with a new one from the pro belt set. However, it keeps running off the front diff pulley, and driving a 710 with just rear wheel drive is rather tricky....
Any idea how to fix this? I've been using the diff for months now, and never had any problem with it, until now.
(Upon close inspection, I discovered that my chassis is very slightly bent. If I put it on the hudy blocks it wobbles very slightly... Can this cause those kinds of problems?? Is the new team chassis any good, in case I decide to replace the chassis altogether?)
Had the same problem some months back...still haven't figured out why but found a good remedy by Art Carbonell...
Use the flange from the oneway pulley and hold it down with an o-rings. I'd grease the o-ring a little with AE GreenSlime coz it'll rub a little with the diff bearings. Run it for a while and eventually the o-ring will will flatten itself and seat nicely...
