After suffering "Servo Tweak" using the stock universal servo mounts on my T-Fource I purchased some CRC aluminum ones. Well..... my Futaba S9602 is too wide and is way off center of the pre drilled holes in the chassis... My question is is the JR z3550 the only one that will fit those holes properly or will the Airtronics 94145 fit as well. The reason I ask is because all the pictures I see of CRC cars have the JR servo in them... I can aquire a 94145 cheaper then I can a z3550 so if the 94145 fits just as good I would rather go that route. Besides I only use Airtronics servos in all my other cars. This stupid Futaba came with the car. So if any ones wants it I'll sell it pretty cheap....

Thanks in advance!